Belt Drive project
02-23-2013, 03:24 PM
#1
Belt Drive project
I am working on a gear drive project and in need of an old crankcase from a DLE 30,50 or 55. The 50 or 55 would be better.
All I need is the lower crankcase forward.I dontneed the carb, reed, ign. or top end.
If someone has an engine that is fried on the top end and looking to get rid of it I will be interested. Since the prototye will be cut downcaseand the crank turned down on the lathe... I dont want to spend 150 on new parts if I dont have too.
WIll post pics as this develops.
The CADdrawings are complete on Revit design program to time to build it.
All I need is the lower crankcase forward.I dontneed the carb, reed, ign. or top end.
If someone has an engine that is fried on the top end and looking to get rid of it I will be interested. Since the prototye will be cut downcaseand the crank turned down on the lathe... I dont want to spend 150 on new parts if I dont have too.
WIll post pics as this develops.
The CADdrawings are complete on Revit design program to time to build it.
