Mintor 22 Piston
06-22-2016, 05:45 AM
#151
My Feedback: (19)
Thrust buttons don't usually work on gas engines because the cylinder walls are not continuous. They have intake ports that would snag the buttons. It could be done but would require redesign of the ports to provide a solid cylinder wall for the buttons to work against.
07-01-2016, 10:05 AM
#152
Senior Member
Thread Starter
My Feedback: (4)
Join Date: Jan 2004
Location: Blackfoot ,
ID
Posts: 2,251
Likes: 0
Received 0 Likes
on
0 Posts
The Mintor line of engines has the poorest set of wrist pin keepers I have ever seen .It supprises me that any of them stay in place long enough to make it thru the first tank.
07-01-2016, 08:00 PM
#153
07-05-2016, 04:19 PM
#154
Senior Member
Thread Starter
My Feedback: (4)
Join Date: Jan 2004
Location: Blackfoot ,
ID
Posts: 2,251
Likes: 0
Received 0 Likes
on
0 Posts
A keeper like the DLE engines use would be fine, or even an eclip type of a keeper ,but a .020 round wire that fits in a groove is not the best thing I have seen. Plus there a bugger to remove and replace.
07-05-2016, 06:00 PM
#155
Best Regards John
06-11-2020, 04:38 AM
#158
Good morning my RCU friends. I've been trying to reach Captnjohn but PM's don't work so hopefully even though this is a very old thread he might see my posting and respond. Cheers.
