WHICH VESS PROP ON A DA-50 FOR 3D???
11-13-2006, 01:25 PM
#1
Thread Starter
My Feedback: (66)
Join Date: Jul 2003
Location: Levittown,
NY
Posts: 117
Likes: 0
Received 0 Likes
on
0 Posts
WHICH VESS PROP ON A DA-50 FOR 3D???
I have a 16lb. QQ Yak with a DA-50. Any recommendations as to which Vess prop would be better for 3D, the 23A or 23B?
Thanks,
Larry
Thanks,
Larry
11-13-2006, 01:41 PM
#2
Senior Member
My Feedback: (5)
Join Date: Jun 2004
Location: Ofallon,
MO
Posts: 673
Likes: 0
Received 0 Likes
on
0 Posts
RE: WHICH VESS PROP ON A DA-50 FOR 3D???
I think the 23b is a bit too much prop for the DA. I have heard reports of the 23a having allot of pull out of a hover but not much speed.....those vertical lines go slow....but it doesn't run out of steam. I believe most people are using a 22b or 23a on a DA 50.
11-13-2006, 10:01 PM
#4
Senior Member
My Feedback: (19)
Join Date: Feb 2002
Location: Redmond,
WA
Posts: 618
Likes: 0
Received 0 Likes
on
0 Posts
RE: WHICH VESS PROP ON A DA-50 FOR 3D???
I am using the 23B as recommended By DA. It is a great combination. This setup is the same as that of Jeff(I think) at DA with the same TOC YAK that I have. It outpulls the Menz that I was using.
11-15-2006, 01:21 PM
#5
My Feedback: (29)
Join Date: Apr 2003
Location: Goldsboro, NC
Posts: 2,834
Likes: 0
Received 0 Likes
on
0 Posts
RE: WHICH VESS PROP ON A DA-50 FOR 3D???
The 23A,, I had one on mine for a while, Robert gave me one to demo when it was a prototype, and I have never switched, I tried the 23b but it loaded the engine up to much when pulling out of a hover,,,
11-15-2006, 02:09 PM
#6
Senior Member
My Feedback: (19)
Join Date: Feb 2002
Location: Redmond,
WA
Posts: 618
Likes: 0
Received 0 Likes
on
0 Posts
RE: WHICH VESS PROP ON A DA-50 FOR 3D???
I got to give the 23A a shot and since everyone seems to like it. Mine does not load up, or at least i do not notice it.
