Copperhead Venom 45
03-31-2011, 11:19 AM
#1326
Member
Join Date: Feb 2006
Location: Lynn Haven,
FL
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
RE: Copperhead Venom 45
My Venom 45 ran very well until the plane was mid-aired. When the engine hit the ground, the case broke into many pieces. As long as your crank holds up you will have a good engine. If you run the plane into anything or have a prop strike you may be done.
03-31-2011, 11:42 AM
#1327
Senior Member
My Feedback: (5)
Join Date: May 2005
Location: Albuquerque,
NM
Posts: 303
Likes: 0
Received 0 Likes
on
0 Posts
RE: Copperhead Venom 45
I have a nearly brand new V45 from back in the day when Copperhead was supporting them. I've run about a gallon of fuel through this thing but it was not quite enough to pull my 16 lb 28% Edge 540T around but it did run great and was very reliable. I replaced it with a G62 clone that does great. I still have the engine but it is kind of an odd size (and weight for its size) to go into many planes. Make me an offer and I'll get it to you with a full money-back guarantee if you don't like it. It would be nice to have a spare or a second to run in another plane. I'll let it go cheap. Let me know if you're interested. I might even have a couple of props that I'll throw in for free. I believe I have a Xoar 21x8 and a couple cheapies.
Thanks,
Gary
Thanks,
Gary
03-31-2011, 12:33 PM
#1328
Member
Join Date: Jul 2007
Location: Selman, OK
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
RE: Copperhead Venom 45
I have a brand new, never been run V 45 that I would sell for any reasonable offer. Not going to fly it since there is no longer any support.
Mike
Mike
01-29-2014, 01:21 PM
#1334
Join Date: Jul 2007
Location: Rio Rancho, NM
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Hello Mike---The engine that you have is it a Venom 45??? Do you have any pics that you could send me??? I well buy it if it is the same as the one I have, You said it was New and never been ran Right??? You can email me back at [email protected] do you want me to pay you?? Thanks Chuck you just made my day and today is my 71 st birthday
02-02-2014, 07:34 PM
#1335
Join Date: Dec 2006
Location: powder springs, GA
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
