3w VOTEC FUN & MT-57
#1
Senior Member
Thread Starter
Join Date: Aug 2002
Location: shanghai, CHINA
Posts: 368
Likes: 0
Received 0 Likes
on
0 Posts
3w VOTEC FUN & MT-57
this plane are design for 3W50 or 3W55, too light compare with 3W55 when install the MT-57 enigne, so need put extra weigh on the nose to balance the plane. looks funny to me .
[link=http://www.youtube.com/watch?v=QV8Dt4xT4oU]3w votec fun and MT-57 engine[/link]
[link=http://www.youtube.com/watch?v=QV8Dt4xT4oU]3w votec fun and MT-57 engine[/link]
#3
My Feedback: (25)
Join Date: Mar 2004
Location: Las Vegas, NV, ANGUILLA
Posts: 262
Likes: 0
Received 0 Likes
on
0 Posts
RE: 3w VOTEC FUN & MT-57
I recently acquired the same header and canister combination from LSPro for my MT - 57. I have to say that this is the best setup that I have used to date. No more brazing header sections to get a good fit. Much quieter than most stock mufflers which create field problems here.
#6
Senior Member
Thread Starter
Join Date: Aug 2002
Location: shanghai, CHINA
Posts: 368
Likes: 0
Received 0 Likes
on
0 Posts
RE: 3w VOTEC FUN & MT-57
this plane are belong to my friend. not my plane wingspen 92.52' (2300 mm) takeoff weight about 18.7lb. use 22-10 prop . seem little small . need 23 size. but still hover less 1/3 power.
#7
My Feedback: (2)
RE: 3w VOTEC FUN & MT-57
Very impressive. I can't wait until I can get my MT57 back in the air, but I am in need of two of me. I don't have enough time in a day to get everything done. I hope to get my Aeroworks Pitts Python flying before winter. It should be a good match as they are coming in from 18 to 19.5 pounds.