djr1007

I'm installing a G38 in a Decathlon and will be using the bellcrank on the throttle. I think I have a an idea of how it goes, but would really like to see a good close up picture of this arrangement if someone else has been thru this already.
Thank You.

RCAddiction

My Feedback: (87)

Did you know there is an Easy Link adapter from Zenoah that rotates the carb on a G38? It replaces the original insulating block between the carb and the engine. It rotates the carb to the correct angle so that you can get a straight linkage to the throttle, without needing a bellcrank. Bellcranks are not hard to do, but there is always going to be a small amount of slop in the linkage compared to a direct link.

http://www.horizonhobby.com/Products...rodID=ZEN13810

Ihave a new G38 EasyLink that Ipurchased to see if it would be the correct angle for another application (Unfortunately not!). Anyhow, if you are interested, just shoot me an email or PM..

arobatx

http://www.bennettbuilt.com/page3.htm

djr1007

If you are saying you'd like to sell the one you have, you got it.
My email is [email protected].
Dan Ribbentrop
4702 E. 24th Street
Tucson, Az 85711.

Shoot me an email with your address or paypal and I'll get you the $ right away.
Thanks!

djr1007

Chad, thanks for that link, I never thought to look there.