Valley View RC
#1
Thread Starter
Valley View RC
I would like to thank Jody from VVRC for taking care of me.... He did some work on my motor, he changed the ring, part of the crankcase, installed new bearings(used to leak from prop hub) and now it runs better than before, and that because its tuned slightly rich... i got 6800 out of a Xoar 23x8 before the most i could get was 65-6600 max. Thank you Jody
P.S. he knew before i even told that i had used amsoil by the carbon pattern on my cylinder head....i guess i made the switch to penzz 40:1 was too late... the rear bearing has spun in my engine, and the old parts i got back verified that...hard to believe but true.... i also took a peak inside my motor through spark plug hole and it was clean as a whistle
P.S. he knew before i even told that i had used amsoil by the carbon pattern on my cylinder head....i guess i made the switch to penzz 40:1 was too late... the rear bearing has spun in my engine, and the old parts i got back verified that...hard to believe but true.... i also took a peak inside my motor through spark plug hole and it was clean as a whistle
#4
Senior Member
My Feedback: (5)
Join Date: Dec 2008
Location: mcallen, TX
Posts: 1,347
Likes: 0
Received 0 Likes
on
0 Posts
RE: Valley View RC
is nice to have someone like Jody... i have learned a lot of things from him about my engine and tune and the service that he made on my engine was amazing.