RCU Forums

RCU Forums (http://www.rcuniverse.com/forum/)
-   General Racing Discussion (http://www.rcuniverse.com/forum/general-racing-discussion-140/)
-   -   Nelson 40 Help (http://www.rcuniverse.com/forum/general-racing-discussion-140/10852640-nelson-40-help.html)

2M86 12-10-2011 01:18 AM

Nelson 40 Help
 
1 Attachment(s)
Good Morning.
I have an old version of Nelson 40.
I need the rear ball bearing, the dimensions are 19x30mm.
Anyone know where it is possible to find this ball bearing?


Thanks,

Max.

jaka 12-10-2011 07:13 AM

RE: Nelson 40 Help
 
Hi!
Ball bearings (Swiss WIB C4 bearings) are available from Dave Shadel at Performance specialties in Nevada!

rbg 12-11-2011 02:29 PM

RE: Nelson 40 Help
 
Boca Bearing has these bearings...

kommander 12-11-2011 09:06 PM

RE: Nelson 40 Help
 
If your crankshaft is 19mm in diameter I believe you assemble the balls directly on the crankshaft along with the outer race of the bearing. I think you need a 30X17X7mm bearing then pop out the retainer, assemble the balls on the crank along with outer race, then pop the retainer back in, then install the crank with bearing in the case. Not completely sure because the pictures of your motor are blurred, hope I've helped.


All times are GMT -8. The time now is 06:29 AM.


Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.