Bud Nosen Trainer-Scratch Build
#1
Thread Starter
Join Date: Feb 2008
Location: duluth, MN
Posts: 237
Likes: 0
Received 0 Likes
on
0 Posts
Bud Nosen Trainer-Scratch Build
[b]This thread starts on pg 8, In Giant Scale Tri-pacer b][&o], ,Frist I was E-mailed the plans / 2nd to the printer $17.00 and then we located a short kit for the wings on ebay,Very nice work for $50.00 . Then we put together a Landing Gear ..That was fun , Go to Giant Scale Tri-pacer.... for more on this build
Thanks
Thanks
#8
RE: Bud Nosen Trainer-Scratch Build
You might want to review my thread , http://www.rcuniverse.com/forum/m_86...tm.htm#8627790 and see if you want to address any of my planes issues. I am thoroughly convinced the tail moment needs to be longer and the fin rudder enlarged when using a big gas motor.
I have test flown about 5 airplanes since my Nosen trainer with zero problems ... the Nosen trainer beat me 3 out of 4 attempts to make it work... Maybe it was just my plane, or me.. But in case you hadn't read my thread .... I thought I would bring it up...
I have test flown about 5 airplanes since my Nosen trainer with zero problems ... the Nosen trainer beat me 3 out of 4 attempts to make it work... Maybe it was just my plane, or me.. But in case you hadn't read my thread .... I thought I would bring it up...
#9
Thread Starter
Join Date: Feb 2008
Location: duluth, MN
Posts: 237
Likes: 0
Received 0 Likes
on
0 Posts
RE: Bud Nosen Trainer-Scratch Build
Yes ,sir I have read your thread ,it was very helpful and very well done .you stretched the fuselage if I remember right .I have made a mod to the tail, I went around the outside and added 3/4 inch ,it's not much but it looks right to methat adds 1 & 1/2 inch more height & lenght ==more area ...the plans and instructions state the tail & horiz. stab are not sheeted but monokoted -,if I need more weight to counter a nose heavy airplane ,I will sheet it and go heavy on the paint...Here is wing view with flap ...
#16
Thread Starter
Join Date: Feb 2008
Location: duluth, MN
Posts: 237
Likes: 0
Received 0 Likes
on
0 Posts
RE: Bud Nosen Trainer-Scratch Build
[size=3]Servo rail mounts are installed 1/2 x 1/4 basswood they need a pilot hole drilled, then , screwed down...the receiver gets double sided foam tape,
wing servos just being fitted for size & pushrod measurements[/size]
wing servos just being fitted for size & pushrod measurements[/size]
#19
Thread Starter
Join Date: Feb 2008
Location: duluth, MN
Posts: 237
Likes: 0
Received 0 Likes
on
0 Posts
RE: Bud Nosen Trainer-Scratch Build
The main gear was not as wide as the fuselage ,had to cut it and add twice the lenght from 4 to 8 inches wide.... Here we take a look at the size of the landing gear.. and the sides of the fuselage and window cutting
#24
Thread Starter
Join Date: Feb 2008
Location: duluth, MN
Posts: 237
Likes: 0
Received 0 Likes
on
0 Posts
RE: Bud Nosen Trainer-Scratch Build
More flooring installed & sizing the firewall -Engine mount -looks pretty close to working as per plan .The firewall is not glued in yet,it's just setting there