RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Giant Scale Aircraft - General (https://www.rcuniverse.com/forum/giant-scale-aircraft-general-467/)
-   -   ESM Retract Issues (https://www.rcuniverse.com/forum/giant-scale-aircraft-general-467/11301006-esm-retract-issues.html)

rcfan450 11-17-2012 08:57 PM

ESM Retract Issues
 
I just installed a brand new air retract system and am having issues with them retracting. They pop out and lock ok, but do not go back in with any authority at all - they don't lock. Even when I take the struts off, they don't go back in and lock.

I've check for binding issues and I can easily move the retract hinge all the way in and out (when not under pressure). When it is under pressure I can feel pressure pushing it out, but in the other direction there just isn't good pressure if any at all.

I have the red Robart Valve - started at 2 turns out on the needles and from there went all over, not much difference.

I have a Robart pressure gauge which told me the pressure was always good between 80-100, mostly right around 100 though as I kept pumping it back up thinking it just wasn't pumped up enough.

So if there are no binding issues and pressure is good - where am I going wrong?

Wish I had the cash to just buy electric retracts....

Lifer 11-18-2012 03:12 AM

RE: ESM Retract Issues
 
Check for any debris or obstruction in the lines for the retract cycle.

VIRGINIA MODEL BUILDERS 11-18-2012 04:15 AM

RE: ESM Retract Issues
 
Most of us have moved on and use the ESM electric retracts

rcfan450 11-18-2012 09:02 AM

RE: ESM Retract Issues
 


ORIGINAL: VIRGINIA MODEL BUILDERS

Most of us have moved on and use the ESM electric retracts

Hence my statement... Wish I had the cash to just buy electric retracts....

I will check for debri. Any other ideas?

Lifer 11-18-2012 09:26 AM

RE: ESM Retract Issues
 
Double check the valve for normal function as well. Best of luck.

rcfan450 11-18-2012 08:14 PM

RE: ESM Retract Issues
 
Figured it out. The ESM quick couplers I got are way too restrictive. I took them off and put the valve directly to the in/out lines and it worked great. So I ordered some Robart quick release connectors, I'll give them a try I guess.

Lifer 11-19-2012 03:14 AM

RE: ESM Retract Issues
 
Good job! Glad you were able to fix them rather than bearing the expense of electrics. A lot of the problems with discounted products is their failure to clean the components prior to assembly. After a while, disassembly and cleaning becomes a routine after purchase.


All times are GMT -8. The time now is 05:27 AM.


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.