Pull pull setup question
Hello I have setup my 30cc beaver with the rudder and tailwheel cables to the servo using a pull pull setup. I have crimped the cables without the classic outer loop, the first flights the cable seems hold the tension well is there any problem going this way?
|
It will be fine
|
If the cables are nylon coated you can add a drop of medium CA into the crimp for a little added security.
|
If this is your first time using pull-pull, don't be surprised that the cables will loosen, due to stretching. Great way for controls. For the next one or if you ever replace these lines, just as a suggestion, hang some weight with the pull-pull wire for about a week to pre-stretch it. I used to use 5-10 pound lifting bar weights. I have actually used pull-pull on both elevators too on one plane. Worked very well.
|
Just curious as I fly year-round. Do you ever have any problems in the cold with wires contracting too much and causing problems?
|
Having flown in the cold winter months in NH, I have not experienced any problems with pull/pull set-ups in my planes.
|
I’ve used pull-pull on all surfaces on a few planes to keep from having non scale hardware visible. I’ve never had a failure with that setup.
Bill, Waco Brother #1 |
All times are GMT -8. The time now is 07:45 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.