.051 TEE DEE glow convertion question
#1
Senior Member
Thread Starter
Join Date: Oct 2003
Location: dublin, CA,
Posts: 148
Likes: 0
Received 0 Likes
on
0 Posts
.051 TEE DEE glow convertion question
So I have a built up balsa plane the motor requierments are for a .051 TEEDEE Motor. What do you think would be a electric equivilant considering 3 cell 1200 lipos and multi stator cd rom..
The air frame with no electronics is 15oz 32inch span canard bipe..
Or for that mater is there is documented motor conversion charts point me there...
I like the idea of teh CD-Rom motors I scavanged 100 of the same motors so I have lots of parts to build with. stators are 23.3mm and I have room for 1mm mags so if i use 2 1/2 stators in a custom can i can get a 10x5x1 mags in it figure 14 or 15 turns and n50 mag's
Anyway any thoughts would be great
The air frame with no electronics is 15oz 32inch span canard bipe..
Or for that mater is there is documented motor conversion charts point me there...
I like the idea of teh CD-Rom motors I scavanged 100 of the same motors so I have lots of parts to build with. stators are 23.3mm and I have room for 1mm mags so if i use 2 1/2 stators in a custom can i can get a 10x5x1 mags in it figure 14 or 15 turns and n50 mag's
Anyway any thoughts would be great
#2
RE: .051 TEE DEE glow convertion question
You already got it figured out! sounds like a very potent 0.051 replacement to me. just wind it for 12-15Amps or so with the desired prop. 8-9x7 for speed or 10x4,7 for 3D. by choosing a 9x7 over the stock 0.051 6x3(?!) you gain about 50% more eff%!