Anyone using the Crain Engineering on board glow driver ?
#1
Thread Starter
Join Date: Sep 2013
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
Anyone using the Crain Engineering on board glow driver ?
It was advertised here a while back on " new products ". I purchased one, but am not finished with the build. It will be used for a Saito 1.80 inverted & cowled in. It is a nice looking device, just wondering if anyone has used this particular product ?
#2
Found only one reference to it, seems like a good product with good support!
http://www.rcgroups.com/forums/showp...31&postcount=7
http://craineng.net/
http://www.rcgroups.com/forums/showp...31&postcount=7
http://craineng.net/