NoOneFlysAtMyClub

My Feedback: (32)

There used to be a guy on RCU that would straighten bent crankshafts. I thought it might have been Flyboydave. I PM'd him but got no response.
Must be someone else?

Thanks, Tony

1QwkSport2.5r

I haven't seen FBD on here in quite awhile. It may very well have been him, but he's MIA I guess. Not sure who else does it - sorry I'm not much help.

NoOneFlysAtMyClub

My Feedback: (32)

Thanks for the reply.

Hobbsy

My Feedback: (102)

Daver, sold all his RC stuff and his motorcycles and now shoots guns for fun.

All Day Dan

My Feedback: (5)

Try here. Dan.

http://aeroscott.com/contact/

ccostant

My Feedback: (38)

Ralph Cunningham use to straighten cranks. Not sure if he is still doing it.

There's a few contacts in this thread.

http://www.rcuniverse.com/forum/gas-...38-cranks.html

spaceworm

There is another recent thread on bent cranks here on RCU, however it was specific to a pair of G38 engines. Perhaps a search on RCU with the title "bent cranks" will bring it up as well as others on the subject, with suggestions for someone to fix the problem. Good luck.

ccostant

My Feedback: (38)

That's the link I posted. Just click on Bent G38 Cranks. The url should take you to that thread.

smithfj

http://www.bj-model-engines.com/

He has done work for me a couple years ago and he does good work.
FRank

NoOneFlysAtMyClub

My Feedback: (32)

Thanks all. I have contacted both companies.

blw

My Feedback: (3)

Dave is also into Ham radio big time too, along with shooting as a hobby.