misfitsailor

My Feedback: (6)

I have heard a rumor that YS, long ago had a four stroke open rocker of about .40 size. Does anyone know their YS history and can shed a little light on the question? I have searched the 'net over and can find nothing.

loughbd

Nope. YS never made a 4 cycle smaller than a 60 and it had covered rockers.

Hobbsy

My Feedback: (102)

Uh oh, where did this .53 come from?

loughbd

Why those sneaky little japanese engineers at Yamada snuck this in without telling me. Oops I forgot about the 53. However, YS never made an open rocker engine.

Cyberwolf

My Feedback: (4)

OS is the only one I know of that made a open rocker 4 stroke.

Iflyglow

My Feedback: (79)

Saito made a Vintage .30 and a .40. I have seen them at swap meets and on EBAY.

loughbd

Enya Made a open rocker 35 and 40 and saito made two versions of a 30 open rocker and a 40. I own all of them

jessiej

I have an open rocker Saito 30, but it is missing a pushrod. Anyone know where I might get one?

jess

Iflyglow

My Feedback: (79)

There used to be a distributer or service center in Texas years ago for Saito. I had picked up a obselete but new exhaust stack for a Saito .80-90 twin to use on my 100T. I did not like the flex pipes. I had got these back around 1995. I cannot remember the name of the place, but it was an autherized Saito repair place. You could also check ebay, or maybe William in the saito club.

Motorboy

The oldest japanese 4 stroke i belive was Kalt FC-1, the engine came in the marked allready in 1977-78..

Jens Eirik

donkey doctor

Hello; Here are a few early open rocker engines. The Enya 40 doesn't show too well amongst all those 46's. Then there is the OS 60, but I can't find a picture of that.

loughbd

You can make one out of music wire. I did it on one of my old OS FS 75's. Worked fine

loughbd

That Saito service center is long gone.

loughbd

Nope, the first production four cycle glow engine was the OS FS60. It was released in 1976. Came in five versions including a marine version. I have all 5. It was released in 76 but Mr. Ogawa of OS was using a prototype a couple years before. The OS 60 started the four cycle revolution and Enya started the horsepower war. Clarence Lee made his famous (infamous?) comment about the OS 60 when it came out. He said he could see no practical use for a four cycle engine in R/C.

26ray

My Feedback: (2)

Dont forget about ENYA, they also made several open rocker engines. I would post a pic of my OR Enya's but I'm at work and they are at home. So it will have to wait. Also, OS OR also came in a Marine version with water cooled head. I belive that Saito also had a marine version, VERY limited production, or 1 or 2 years only and that was over 20 years ago.... hehe I was just a kid then Hum... I still am a kid, or at least my wife says so.

loughbd

There is a picture of an Enya back in this thread. Enya made two 4 cycle open Rocker. A 35 and a 40. Saito never made a Marine 4 cycle. They made an ignition schneurle ported gasoline two cycle that was water cooled.

26ray

My Feedback: (2)

Ok, I'm home now. Here are a few pics of my Enya OR engines and one of my Saito 30's I saito looks kinda neat like this, it reminds me of an oldtimer ignition engine (but its not).

Also, I OS 40, that I converted to an open rocker just because I felt like it. It runs great and my brothernlaw is currently flying it in some wombat or somthing, not sure but its got a twin tail.

loughbd

They look just like the other Enyas posted earlier in this thread.

misfitsailor

My Feedback: (6)

26RAY, I like what you did with the OS 40. But quit hogging all the Enya 35 4C's! (lol)
here are my own open rocker engines; OS FS60, Saito FA30 MkII, Kalt FC-1 (new arrival), English made Magnum 91S.

Motorboy

Hi, here are my open rocker Magnum FS52 Diesel

Jens Eirik

loughbd

Open rocker engines may be nice to look at but not to use in an airplane. The top end gets dirty and wears quicker and the push rods are always getting lost.

All those engines being shown are the last releases. Has anyone got pictures of the first versions?? OS made 3 FS60's prior to the one shown and Saito made an earlier 30 than the one shown.

JimTrainor

Interesting. What size prop does the diesel Magnum 52 use?
Thanks

26ray

My Feedback: (2)

Thanks, That Kalt and magnum are nice engines. Both of those are on my list of wanted engines. I only have seen the Kalt come up for sale about 2 times. and of course both times I was broke... LOL

KEEP THE OPEN ROCKER PICTURES COMING !!!!

We should start a thread, " The Open Rocker Club " Seems to be the in thing.

26ray

My Feedback: (2)

Jens... Nice engine[8D], I like the diesel conversion, do you fly it?

misfitsailor

My Feedback: (6)

Jens, tell us about the diesel compression thingy that goes in the glowplug hole. Did you make that also? I am fascinated by the idea of a working model 4 cycle diesel. I have seen the rare Enya 41 4C diesel, but only few were made.