Tower .61 Engine
#1
Thread Starter
Join Date: Dec 2005
Location: Milan,
IN
Posts: 233
Likes: 0
Received 0 Likes
on
0 Posts
Tower .61 Engine
Over the weekend, I mounted this new engine in my test stand to break it in. It sure is a different engine than the Super Tigre .45 that I test ran a couple of months ago. The needle valve seemed to have little range, going from running slightly rich to overly lean in a couple of clicks. It idled OK without having to fiddle a lot with the low speed needle valve. I ran about 36 oz of 15% Wildcat through. It ran OK, but I couldn't tach the engine because my tach gave up the ghost.
This is my first experience with a remote needle valve arrangement. Does that cause adjustment issues? Also my first experience with a Tower engine. All my older engines have been OS or Super Tigre, which I've been very happy with.
Anyone have info/opinions to share on this engine?
Mike
This is my first experience with a remote needle valve arrangement. Does that cause adjustment issues? Also my first experience with a Tower engine. All my older engines have been OS or Super Tigre, which I've been very happy with.
Anyone have info/opinions to share on this engine?
Mike