Ace Pulse Commander Repair
02-24-2014, 08:48 PM
#1
Thread Starter
Ace Pulse Commander Repair
I moved this to a new post:
Hi Jaymen,
It was suggested on this forum today, that I should contact you about needing to repair or replace my broken Ace Pulse Commander. Its electronics suddenly went dead yesterday, and I haven't been able to get it going again, despite careful inspection of all wires, components for looseness. If I can get the electronics going, I can repair the broken stick yoke clamp holding the stick pot, but I don't want to go to that trouble unless the electronics are working. Do you have any interest in this project? Or a used but working Ace Pulse Commander you want to let go of?
Please advise and thanks a lot.
Response:
Hello Bill,
I can repair the Pulse Commander for you. Contact me at
[email protected] or 949 699 0439
Hi Jaymen,
It was suggested on this forum today, that I should contact you about needing to repair or replace my broken Ace Pulse Commander. Its electronics suddenly went dead yesterday, and I haven't been able to get it going again, despite careful inspection of all wires, components for looseness. If I can get the electronics going, I can repair the broken stick yoke clamp holding the stick pot, but I don't want to go to that trouble unless the electronics are working. Do you have any interest in this project? Or a used but working Ace Pulse Commander you want to let go of?
Please advise and thanks a lot.
Response:
Hello Bill,
I can repair the Pulse Commander for you. Contact me at
[email protected] or 949 699 0439
