rmracing

This is crazy, first of all the helicopter takes forever to bind. I almost gave up, but then I was just flipping switches for a few minutes on the controller and I heard it bind (this is a new problem - when I first got it, it bound up fine). Then everything seems to work, but I can't fly it because I have no tail rotor control with the left stick. I can (when light on the skids) rotate/yaw the heli using the right/left trim setting on the controller. left/right yaw stick is dead, but trim works. Assuming my transmitter is messed up, anyway to hard reset it? If I turn it on by itself, it only blinks for 3 seconds and then goes solid, regardless if it binds or not.

Thoughts? Should I waste time on this or are my efforts futile. If the heli is a POS (which would suck since I loved the CX, flew it for hours and hours), I'll just forget about it and move on.

Thanks,

Robby