LAma to Shuttle Conversion
#1
Thread Starter
LAma to Shuttle Conversion
Been flying my Lama for 3 seasons now and was thinking of converting it to the new Shuttle version. Can anyone tell me the parts I need to order?
#2
Senior Member
Join Date: Dec 2004
Location: Edison,
NJ
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
RE: LAma to Shuttle Conversion
Sure, Here you go
0301-104 cabin 17.50
0301-106 skids 11.50
0301-105 tail assy 25.50
0301-112 decal sheet 11.50
Then paint the pod section black to match the tail assy or paint the rear frame section of the tail assy silver to match the pod.
Jeff
0301-104 cabin 17.50
0301-106 skids 11.50
0301-105 tail assy 25.50
0301-112 decal sheet 11.50
Then paint the pod section black to match the tail assy or paint the rear frame section of the tail assy silver to match the pod.
Jeff
#4
Member
Join Date: Feb 2004
Location: Singapore, SINGAPORE
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
RE: LAma to Shuttle Conversion
ORIGINAL: mrc-hirobo
Sure, Here you go
0301-104 cabin 17.50
0301-106 skids 11.50
0301-105 tail assy 25.50
0301-112 decal sheet 11.50
Then paint the pod section black to match the tail assy or paint the rear frame section of the tail assy silver to match the pod.
Jeff
Sure, Here you go
0301-104 cabin 17.50
0301-106 skids 11.50
0301-105 tail assy 25.50
0301-112 decal sheet 11.50
Then paint the pod section black to match the tail assy or paint the rear frame section of the tail assy silver to match the pod.
Jeff
instead painting the main frame set, can we use the main frame set from the mini-shuttle part list? i mean i am pro originality. but i a question too (can't recall if i have asked you earlier) is there a special technique to assemble the main frame set of the XRB, especially the antenna side's servo cover/capping.
please advice.
thanks!
mike