starting problem
#1
Junior Member
Thread Starter
Join Date: Jul 2008
Location: donegal, IRELAND
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
starting problem
hi i have just bought a shuttle z but is not starting properly.at the top were u put the hexagenal starter shaft,it does not turn over the engine proerly.is this a clutch problem.is there anyway of fixing it. please help!.ryan.
#2
Junior Member
Join Date: Jul 2007
Location: st-martin ,
QC, CANADA
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
RE: starting problem
Hi Ryan,I had this problem last year with my hirobo Lama.The Drive NUT that retains the cooling fan was slack.The fan had raised and was rubing the shroud.If this is your problem,tighten it with threadlocker (Red) Good Kuck Claude