Programming a Servo for a slower speed
01-10-2012, 09:23 PM
#1
Thread Starter
My Feedback: (9)
Join Date: Jul 2003
Location: Pullman,
WA
Posts: 2,221
Likes: 0
Received 0 Likes
on
0 Posts
Programming a Servo for a slower speed
I'm using a programmer to slow a servo. The problem is that the servo speed seems constant from about 100 to 20 percent, and then when I program it to 10 percent it slows dramatically. I'm using the HPP21+ programmer and am trying to program the 5485 servo.
Advice? I'd like to get a speed about half way between full and 10%.
Thanks in advance,
Sam
Advice? I'd like to get a speed about half way between full and 10%.
Thanks in advance,
Sam
01-27-2012, 06:05 AM
#2
Thread Starter
My Feedback: (9)
Join Date: Jul 2003
Location: Pullman,
WA
Posts: 2,221
Likes: 0
Received 0 Likes
on
0 Posts
RE: Programming a Servo for a slower speed
Well I emailed Hitec and received a reply indicating that I will not see much difference between the speeds of 2 to 10.
