Need gearing assistance with brushless conversion on savage x ss.
#1
Senior Member
Thread Starter
Join Date: Aug 2005
Location: huntington Woods,
MI
Posts: 234
Likes: 0
Received 0 Likes
on
0 Posts
Need gearing assistance with brushless conversion on savage x ss.
So I have most of the conversion planned. My main concern now is what pinon to go with. I am using the stock 47t steel spur gear. All the other gearing is stock however, I will be replacing the drive gear with a HD version and will add bullet proof differentials once the originals strip. I would like to keep my torque as low as I can without adding much stress to my motor. Relevant electronics are below:
4s lipo
hk 120a ESC
turnigy track star 2650kv motor.
4s lipo
hk 120a ESC
turnigy track star 2650kv motor.
#2
Senior Member
Thread Starter
Join Date: Aug 2005
Location: huntington Woods,
MI
Posts: 234
Likes: 0
Received 0 Likes
on
0 Posts
RE: Need gearing assistance with brushless conversion on savage x ss.
It just occured to me that my motor should produce the same RPM as my engine on 4s. I am happy with the stock speed so I might as well keep the same tooth count as the stock clutch bell. My next question, Does anyone know what tooth count is on the stock savage x ss clutch bell? Normally I would just count the teeth but my truck is currently out of state (long story) and I can not count it.
#5
Senior Member
Thread Starter
Join Date: Aug 2005
Location: huntington Woods,
MI
Posts: 234
Likes: 0
Received 0 Likes
on
0 Posts
RE: Need gearing assistance with brushless conversion on savage x ss.
Mainne,
What RPM is your motor producing? I will be getting about 39k which is the same that my engine maxes out at. I wonder if 14T will produce enough top end for me. How is heat with your 14t?
What RPM is your motor producing? I will be getting about 39k which is the same that my engine maxes out at. I wonder if 14T will produce enough top end for me. How is heat with your 14t?
#6
Member
My Feedback: (3)
Join Date: Aug 2011
Location: west yarmouth, MA
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
RE: Need gearing assistance with brushless conversion on savage x ss.
39k for me the heat issue it got a little hot but I put a fan on it witch u can get from tower hobbies it sits on top of the motoe and plugs into your receavier
#7
Senior Member
Thread Starter
Join Date: Aug 2005
Location: huntington Woods,
MI
Posts: 234
Likes: 0
Received 0 Likes
on
0 Posts
RE: Need gearing assistance with brushless conversion on savage x ss.
How is your top end with the 14t? do you still think that you can hit around 40mph?