PeeBeMe

HOW EASY AND HOW LONG IS IT TO PUT A PULL START ON MY SAVAGE ?

jikkuria

it's not hard, just pull the motor, take the screws that hold the rotostart, remove it and put the pull start on.

wingedwheel-0420

i dont know..... it might be kinda hard for ya,seeing that you even asked. better get u a "how to" manual

PrjctStrtFrce

My Feedback: (10)

If you have the manual, required tools, and common sense, then it will be a breeze.

rcnitrohead

And stop using caps..

twomanytoys

+1

Nitrocrow

With out an overpull . . . the HPI pull start I just bought and installed . . . failed after about 5 pulls.

I didn't overpull . . . the glue that simply held the string in place inside the coil box . . . let loose and the string came out.

I put my roto back on.

rcnitrohead

Haha I've had that happen to me before... The worst thing about pullstarts is re-winding the springs when they fail. Its possibly one of the most frustrating processes I've gone through in this hobby my first 2-3 times doing it... Expect to have a spare half hour to hour the first time with blistered fingers.

Tom.