Brushless Savage Problem
10-06-2009, 05:06 PM
#1
Senior Member
Thread Starter
Join Date: Apr 2008
Location: olathe,
KS
Posts: 552
Likes: 0
Received 0 Likes
on
0 Posts
Brushless Savage Problem
My savage started to not work today. I had just recharged the batteries and was plugging it. The ESC usually beeps but it didnt so i unplugged it and tried again. Still nothing so i unplugged the servo since it also been a problem before. Finally it beep but when i gave it throttle it started cogging real bad. I tried over and over unplugging and plugging in the servo and the throttle in different combos and still it wouldnt work right. Im thinking its the servo being the problem its not that its to weak it just draws a lot of amps and is just power hungry.
10-06-2009, 08:44 PM
#3
Senior Member
Thread Starter
Join Date: Apr 2008
Location: olathe,
KS
Posts: 552
Likes: 0
Received 0 Likes
on
0 Posts
RE: Brushless Savage Problem
i figured it out. it was my reciever batteries they were shot so now im switching over to a bec. the servo draws alot of amps more the they reciver pack could put out so it just ruined them. oh well live and learn.
