Aerofly 5.5 and jr12x help!
#1
Thread Starter
My Feedback: (30)
Aerofly 5.5 and jr12x help!
Just got my AF5 and then downloaded 5.5. I am having an issue with my switch assignment on my 12 x. When I go to calibrate it gives me channels 1-8. Everything works good in this screen, and then i finish.but when I go to assign switches, gear and flaps, the computer is showing these switches not getting full throw and acting erratic. Anybody gone through this. I was up fr hours tryingnto figure it out. I have it connected correctly with all the adapters..any help would be appreciated..thamks
#6
Thread Starter
My Feedback: (30)
RE: Aerofly 5.5 and jr12x help!
On the road but I will post later. It is setup just like the pics I've seen you post in other threads. I have the adapter i bought separate to the cable to the other thing with the servo wire to the USB. But I am not sure if it's in PPM mode
#7
Moderator
My Feedback: (58)
RE: Aerofly 5.5 and jr12x help!
Please check how many PPM modes are there in the 12x. In my Futaba 14mz, there are two 12-channel PPM modes (N1.3 and N1.5 pulse width) which are not compatible (calibration problems) with the usb interface and I have to use the 8-channel PPM mode which has a N1.0 pulse width.