Aerofly 5.7.1.1 upgrade problem
#1
Member
Thread Starter
Join Date: Jan 2002
Location: Warren,
MI
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Aerofly 5.7.1.1 upgrade problem
I upgraded my MAC AeroFly to version 5.7.1.1 and reactivated the software. The correct serial interface code also appeared. I am using a Futaba 9C transmitter that work great until I upgrade and now AeroFly will not recognize or configure the 9C. When I went to the activation screen again it said the my product was not activated. Any suggestions?
#3
Member
Thread Starter
Join Date: Jan 2002
Location: Warren,
MI
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
RE: Aerofly 5.7.1.1 upgrade problem
I tried that. When I entered my product key I received the message that my product was activated.
I then exited the screen and attempted to configure my controller. When it wouldn't configure I went again to the re-activation screen and it said that my Aerofly was not activated.
I reactivated again and again with the same results.
I then exited the screen and attempted to configure my controller. When it wouldn't configure I went again to the re-activation screen and it said that my Aerofly was not activated.
I reactivated again and again with the same results.