RC7.4.3 not working on my Macbook Pro
#1
Junior Member
Thread Starter
Join Date: Feb 2003
Location: Tasmania, AUSTRALIA
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
RC7.4.3 not working on my Macbook Pro
Hi,
I have installed AeroFly RC7.4.3 on my Macbook Pro however there is something wrong with the install. When I run the program the model transitions well on the runway but when it takes off it goes into loops etc. as though it is trying to do Torque Rolls. I have checked the settings, calibration etc and can find nothing wrong. It runs fine on my IMac? The MB Pro is fairly new.
Any thoughts as to what is wrong?
I have installed AeroFly RC7.4.3 on my Macbook Pro however there is something wrong with the install. When I run the program the model transitions well on the runway but when it takes off it goes into loops etc. as though it is trying to do Torque Rolls. I have checked the settings, calibration etc and can find nothing wrong. It runs fine on my IMac? The MB Pro is fairly new.
Any thoughts as to what is wrong?