Aerofly will not calibrate
I am trying to run Aerofly using a JR10X. It will not calibrate. Any input will be appreciated.
|
Can you share a picture of how you've connected your transmitter to your computer?
|
It plug into a USB port. It recognizes the transmitter, but channel indicator is jumping all over. When calibrate is attempted, the indicators never go to center.
|
Just hooked up my JR 11X transmitter. It does the same thing. Thinking I need to reinstall software.
|
Did you try connecting with the power turned off on the transmitter? Some transmitters need to be off in order to act as a trainer transmitter. Also, can you calibrate within Windows? Also in Windows, do you have more than one joystick defined? You may not be seeing the correct device. Make sure it is selected in the sim or set as the primary controller in Windows.
|
Yes power is off. Program is running in Windows. Where do you define the number of joy sticks. It shows "transmitter" selected Where in Windows do I select the device?
|
Did a reinstallation of software. No different. I can select FLY without the TX connected and it does the same. Surfaces just sit there jittering and motor pulses, same as when TX is connected. So the problem has got to be in setup somewhere.
|
Please post a photo of your cable connection from the radio to the computer. Which type of usb interface cable are you using?
|
All times are GMT -8. The time now is 02:27 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.