twin JR 811 on elevators of 88" laser???
#1
Senior Member
Thread Starter
Join Date: Jan 2002
Location: South, NEW ZEALAND
Posts: 321
Likes: 0
Received 0 Likes
on
0 Posts
twin JR 811 on elevators of 88" laser???
Hey guys
I was just given an 88 inch laser which I am putting a 3W 70i in for extreme power. The thing is I have some JR 811 standard digitals lying around that I want to use on the elevators ( one on each half tail mounted.) Just need you opinion if this is too little servo with the 70 pulling. I will not be using it for 3d just basic imac. I am 100% sure that one driving both would be too little but with both im guessing I might get away with it????
Mike
I was just given an 88 inch laser which I am putting a 3W 70i in for extreme power. The thing is I have some JR 811 standard digitals lying around that I want to use on the elevators ( one on each half tail mounted.) Just need you opinion if this is too little servo with the 70 pulling. I will not be using it for 3d just basic imac. I am 100% sure that one driving both would be too little but with both im guessing I might get away with it????
Mike
#2
Senior Member
My Feedback: (1)
Join Date: Oct 2002
Location: largo, FL
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
twin JR 811 on elevators of 88" laser???
Just my opinion, it will probably be enough but iwould upgrade to some stronger servos. Just remember there will always be that little voice in the back of your head saying"is this the day that those servos will fail or not". Also think about how much money you have invested in the plane. If you have a lot invested then you may want to think about it. Spending a little more money now sure beats spending a lot of money later. Just my onpinon and hope you enjoy your plane