RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Jet Central Turbines - Artes Jet (https://www.rcuniverse.com/forum/jet-central-turbines-artes-jet-139/)
-   -   Cheetahs (https://www.rcuniverse.com/forum/jet-central-turbines-artes-jet-139/11544132-cheetahs.html)

snobird 06-15-2013 12:23 PM

Cheetahs
 
Have cheetahs in my SM a-10. One starts right off ,no issues, the other one stars very hard , will get ignition failures over and over until it finally will start, last start took 12 try's . After start it runs as it should . ?????

BluFox 06-17-2013 07:24 AM

RE: Cheetahs
 
snobird:

Two things to check;

1. did you rotate the turbine in the mounts so the name Cheetah is on top. . .that is facing upward toward the top of the nacelle? Please do so if not already accomplished.

2. "Ignition fail" is just that. . .failed to get ignition. The manual describes the parameter to be adjusted if you get failed ignition. Also, please check both the 3mm and 4mm lines from your fuel source to the turbine for any restrictions.

Thanks for the question

Eric

snobird 06-17-2013 10:50 AM

RE: Cheetahs
 
Thanks. Eric .both turbines have the name on their side. ill change. this is news to me. name facing up..thanks


All times are GMT -8. The time now is 09:53 AM.


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.