Jet Tronic software
#1
Member
Thread Starter
Join Date: Apr 2002
Location: Auckland, NEW ZEALAND
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
Jet Tronic software
I have a problem with this software on my new Win10 system. I use the older serial cable.
When installing I get an error message 'unable to register DAO350.DLL', by ignoring the message the installation finishes.
I can then run the software and the ECU is recognised ok.
The only problem is when I download the data from the ECU and save it I cannot load the saved file back to the program (the load file window is blank even though I can view the file in exploprer), I guess this has something to do with this DLL file.
Anyone have this and managed a fix?
Ron
When installing I get an error message 'unable to register DAO350.DLL', by ignoring the message the installation finishes.
I can then run the software and the ECU is recognised ok.
The only problem is when I download the data from the ECU and save it I cannot load the saved file back to the program (the load file window is blank even though I can view the file in exploprer), I guess this has something to do with this DLL file.
Anyone have this and managed a fix?
Ron
#3
Member
Thread Starter
Join Date: Apr 2002
Location: Auckland, NEW ZEALAND
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
I did not expect it to work until the DAO350.DLL file got registered so Win7 must not need it?
Thanks
Ron