p160sx smoke setup
#1
Member
Thread Starter
Join Date: Jan 2005
Location: Nes zionna, ISRAEL
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
p160sx smoke setup
Hello.
I have the p160sx with the internal kerostart plug.
Where (in the turbine) should i conect the pressure line for pressurizing the smoke tank(not using smoke pump) ?
I have the p160sx with the internal kerostart plug.
Where (in the turbine) should i conect the pressure line for pressurizing the smoke tank(not using smoke pump) ?
#4
My Feedback: (10)
RE: p160sx smoke setup
Hello,
Sorry for the late reply, we had to think about this one.
No one has tested this at JetCat USA, and therefore I would not recommend using the auxiliary port for smoke system pressure.
You can always use the ECU port to control a JetCat smoke pump or any third party smoke pump that can trigger with a 5 volt TTL signal.
Regards and sorry again for the late reply,
Sorry for the late reply, we had to think about this one.
No one has tested this at JetCat USA, and therefore I would not recommend using the auxiliary port for smoke system pressure.
You can always use the ECU port to control a JetCat smoke pump or any third party smoke pump that can trigger with a 5 volt TTL signal.
Regards and sorry again for the late reply,