P300 RX poping at Idle
Hi just installed a P-300RX which came back from service, at Start up I get plenty of flames and at Idle there is quite a bit of poping , any suggestions would be greatly appreciated.
I am using diesel, Thanks in Advance J.C. Alvarez |
Did you do a full power run? Its gone back into an airframe it was in before, where its didn't 'pop' in the tail pipe? It was always run on Diesel?
|
Hi Dave, thanks for nthe quick reply,
1. Yes I did a full power run up and no problems it accelerates just fine and reaches 104000 rpms 2. no it is not in the same airframe gap at pipe is 1 inch approx. 25 mm 3. no previously I ran on Kerosene thanks J.C. |
OK. Gap is too small. What dia pipe? If it’s around 105mm the gap should be 40-45mm
Dave |
Originally Posted by Dave Wilshere
(Post 12560421)
OK. Gap is too small. What dia pipe? If it’s around 105mm the gap should be 40-45mm
Dave I have heard that some Jet Cat Turbines do no run good on diesel is correct ? Once again thank you, J.C. |
I’ve never used Diesel, I thought only the smaller turbines were fussy on fuel. Gap will add a bunch of power and should help on the air popping
|
Hi Dave, tried kerosene and poping improved 90 % , I then moved the turbine as you suggested poping is still the same with 90 % improvement, I also tried the diesel again and poping returned.
Going to run it on kerosene . Once again thanks for all your help J.C. Alvarez |
Get a new pump.
|
Originally Posted by Springbok Flyer
(Post 12560645)
Get a new pump.
Thanks for the input J.C. |
All times are GMT -8. The time now is 07:04 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.