AR 9200 sensor switch
#1
Member
Thread Starter
Join Date: May 2004
Location: RomaRM, ITALY
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
AR 9200 sensor switch
Hello,
I have just purchased the new AR9200 Power safe evolution rx. When tried to turn it on first time, the sensor switch did not recognize the battery type.. Tried with a 5 cell Nimh and with a LiFePo4 , same result: the red led lights up and stays lit, it does not act as the manual says...I made an adapter to go from a JR type plug to Mpx connecting * to * and -to- ( The nimh battery has 2700mah capacity and it is fully charged) The LiFePo4 is new and I am not sure it is fully charged.
When the switch red led was on I tried to turn on the rx but it the leds on the rx blink green briefly and then the red (stop)starts blinking continuosly....
Can anybody help?
Thanks - Dino
I have just purchased the new AR9200 Power safe evolution rx. When tried to turn it on first time, the sensor switch did not recognize the battery type.. Tried with a 5 cell Nimh and with a LiFePo4 , same result: the red led lights up and stays lit, it does not act as the manual says...I made an adapter to go from a JR type plug to Mpx connecting * to * and -to- ( The nimh battery has 2700mah capacity and it is fully charged) The LiFePo4 is new and I am not sure it is fully charged.
When the switch red led was on I tried to turn on the rx but it the leds on the rx blink green briefly and then the red (stop)starts blinking continuosly....
Can anybody help?
Thanks - Dino