Dual rate switch will not switch JR7202
#1
Senior Member
Thread Starter
My Feedback: (79)
Join Date: Jan 2002
Location: Sturgeon Bay,
WI
Posts: 260
Likes: 0
Received 0 Likes
on
0 Posts
Dual rate switch will not switch JR7202
To make a long story short, on my 7202 when I want to switch from "0" to "1" nothing happens. So from going to low rates to high is a moot point. Anyone else ever have this happen. I'm hoping this does not mean a shipment to Horizon. Help!!!!!!!!!!!!!!!! Joe
#2
My Feedback: (2)
RE: Dual rate switch will not switch JR7202
ORIGINAL: JL636
To make a long story short, on my 7202 when I want to switch from ''0'' to ''1'' nothing happens. So from going to low rates to high is a moot point. Anyone else ever have this happen. I'm hoping this does not mean a shipment to Horizon. Help!!!!!!!!!!!!!!!! Joe
To make a long story short, on my 7202 when I want to switch from ''0'' to ''1'' nothing happens. So from going to low rates to high is a moot point. Anyone else ever have this happen. I'm hoping this does not mean a shipment to Horizon. Help!!!!!!!!!!!!!!!! Joe
What Receiver are you using?
These are just questions to help better understand your situation.
I have not had this happen to me, but once in a while we hear about someone with glitches in the Tx programming.
#3
Senior Member
Thread Starter
My Feedback: (79)
Join Date: Jan 2002
Location: Sturgeon Bay,
WI
Posts: 260
Likes: 0
Received 0 Likes
on
0 Posts
RE: Dual rate switch will not switch JR7202
Did a "reset" and got the aileron dual rate to work. Now the problem of getting the switch to go between the "0" and "1" position has moved to the elevator! Has to be something I'm doing wrong. has to be. Joe
#4
My Feedback: (2)
RE: Dual rate switch will not switch JR7202
ORIGINAL: JL636
Did a ''reset'' and got the aileron dual rate to work. Now the problem of getting the switch to go between the ''0'' and ''1'' position has moved to the elevator! Has to be something I'm doing wrong. has to be. Joe
Did a ''reset'' and got the aileron dual rate to work. Now the problem of getting the switch to go between the ''0'' and ''1'' position has moved to the elevator! Has to be something I'm doing wrong. has to be. Joe