DX8 retract problem
#1
Senior Member
Thread Starter
Join Date: Jan 2002
Location: montreal,
QC, CANADA
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
DX8 retract problem
Hello,
I seem to have a problem with the retract system upon powering up.
The radio (DX8) is powered first followed by the receiver. Even though the retract switch is in the down position, the servo (on it's own) will cycle to the retracted position and then back to the down position even though the switch has not been toggled.
This only happens, as I mentioned, on power up.
What is the problem ?
I seem to have a problem with the retract system upon powering up.
The radio (DX8) is powered first followed by the receiver. Even though the retract switch is in the down position, the servo (on it's own) will cycle to the retracted position and then back to the down position even though the switch has not been toggled.
This only happens, as I mentioned, on power up.
What is the problem ?