DX11X Elevons and elevator mix
#1
Junior Member
Thread Starter
Join Date: Jan 2006
Location: Gold Coast, AUSTRALIA
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
DX11X Elevons and elevator mix
Currently finishing off a turbine Gloster Javelin and want to include elevons with the elevator to minimize the tailplane stall blanking which this model is prone to at high alpha.
I have tried several mixes but cannot isolate the elevator when; Wing - Delta is enabled, the elevator acts like another aileron.
Anyone have an answer please?
Brian
I have tried several mixes but cannot isolate the elevator when; Wing - Delta is enabled, the elevator acts like another aileron.
Anyone have an answer please?
Brian
#2
My Feedback: (5)
RE: DX11X Elevons and elevator mix
I don't believe there is that much difference between the DSX11 and the 11X sold in North America. When my 11X is set to Delta wing type, there is no problem with mixing the pitch to another channel.
Inhibit a channel, say AUX2, and call it your elevator that is not part of the elevons. Then just mix ELEV -> AUX2. In the program mix, ELEV refers to the pitch motion of the elevon. With this mix, the elevon roll action is not sent to AUX2.
Allan
Inhibit a channel, say AUX2, and call it your elevator that is not part of the elevons. Then just mix ELEV -> AUX2. In the program mix, ELEV refers to the pitch motion of the elevon. With this mix, the elevon roll action is not sent to AUX2.
Allan