servo setup menu is backwards
#1
Senior Member
Thread Starter
My Feedback: (34)
Join Date: Dec 2001
Location: tishomingo, OK
Posts: 233
Likes: 0
Received 0 Likes
on
0 Posts
servo setup menu is backwards
hello......im in the process of moving my planes from a dx-6i to a dx-7s......when im adjusting the end points i have to put the box on the up percent numbers to adjust the down end point travel. its happening on all 4 channels....to adjust the throttle high end throw, i have to put the selecter on the low end throw.....the servo does not move when adjusting the per cent numbers with the adjusting wheel...very confusing!..........any advice.....pault
Last edited by pault; 10-06-2013 at 06:36 PM.
#3
Senior Member
Thread Starter
My Feedback: (34)
Join Date: Dec 2001
Location: tishomingo, OK
Posts: 233
Likes: 0
Received 0 Likes
on
0 Posts
i just got off the phone with product support.......they told me that there is a firmware problem with the radio....i had to go to spektrumrc.com and download tha firmware update 1.03. this fixed it......pault