Spectrum AR8000
#1
Thread Starter
My Feedback: (7)
Join Date: Jan 2004
Location: Parrish,
FL
Posts: 206
Likes: 0
Received 0 Likes
on
0 Posts
Spectrum AR8000
I am looking to run two power lines to my AR8000, just for redundancy. However, I need seven channels for servos and kill switch. Can I plug a power lead into the bind port after the receiver is bound? On some receivers this is possible, but I hate to experiment on a new airplane.
Thanks
Tony
Thanks
Tony
#4
My Feedback: (4)
Join Date: Jan 2002
Location: Prague, CZECH REPUBLIC
Posts: 4,144
Likes: 0
Received 0 Likes
on
0 Posts
On a electric setup, I also plug a Y into the bind port for binding with a regular Rx pack (one end bind plug, other end batt ) so I don't have to plug the lipo (don't have to worry about the prop chopping my fingers... )
Hope this makes sense,
Cheers, V.
Last edited by vasek; 11-08-2013 at 07:56 AM.