dx6 black updates all went well but wont bind
#1
Junior Member
Thread Starter
Join Date: Feb 2016
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
dx6 black updates all went well but wont bind
i did all the updates as listed in my update file .all seemed ok until would not bind to any of my planes. anybody had this issue.
#5
Senior Member
Join Date: Sep 2007
Location: Sanger,
CA
Posts: 427
Likes: 0
Received 0 Likes
on
0 Posts
Ok.Not in EU. The update didnt change the Bind data. So the model you had before the update should still be bound. I think your saying that now it wont Connect. Binding is done once to get a Rx linked to the Tx and model memory position. Then it Connects.
All other powerups after that are Connections.
Without initiating an actual Bind and you just turn the Tx on normally the orange led and bars on the front will blink a time or 2 but should then come on solid in a few seconds. If the orange bars dont come on it means the RF is not active. If this is the case it must be returned for service.
If the orange bars are lit up but the Rx is refusing to Connect you can try to Bind again.
All other powerups after that are Connections.
Without initiating an actual Bind and you just turn the Tx on normally the orange led and bars on the front will blink a time or 2 but should then come on solid in a few seconds. If the orange bars dont come on it means the RF is not active. If this is the case it must be returned for service.
If the orange bars are lit up but the Rx is refusing to Connect you can try to Bind again.
#7
Junior Member
Thread Starter
Join Date: Feb 2016
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
as i said i would retry updates, went to spektrums instructions and formatted on their link they like using a sandisk 4 gig . reloaded both updates again and now all is fine.don't have to send for service.