JR Radio & Spektrum Radios Discuss all your JR and Spektrum gear.

DX& Flaps Programming

Reply

Old 03-23-2017, 01:25 PM
  #1  
Confuqua
Junior Member
Thread Starter
 
Join Date: Jun 2003
Location: Tucson, AZ
Posts: 21
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default DX& Flaps Programming

I am trying to set up a new E-Flite Commander, using a DX7 transmitter. Everything works normally except the flaps. Although the flaps will operate using the rocker switch, they will not respond to the 3 position flap switch.

Flaps work normally with the 3 position switch programmed for a P-47 with the same set of control surfaces.

Both models have the following settings: (among others)
Wing Types all OFF

Input Select Aux2: 2 position switch
Aux2 Trim: INH
Flap: System
Flap Trim: ACT

The P-47 Flap System is set to:
Norm: Flaps UP 110%, Elevator 0%
Mid: Flaps UP 24%, Elevator 0%
Land: Flaps DOWN 72%, Elevator 0%
Auto: INH

The Commander Flap System is set to:
Norm: Flaps UP 100%, Elevator 0%
Mid: Flaps 0%, Elevator 0%
Land: Flaps DOWN 100%, Elevator 0%
Auto: 0%

The obvious difference is the INH versus 0% in the Flap System setup. I cannot figure out how to get the Commander set up to INH.

Again, the P-47 flaps work as desired using the 3 position switch. Any help will be greatly appreciated.
Confuqua is offline  
Reply With Quote

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service