DX18 Gen1 telemetry question
07-29-2017, 12:31 AM
#1
Thread Starter
DX18 Gen1 telemetry question
I have a DX-18 Gen1 and would like to know if there is a way to set up telemetry for two turbines? Engines will be Jetcat P-60SE with Kero start plugs.
If this somehow can be done can I leave the throttles on Y leads or do they both need a seperate channel?
If this somehow can be done can I leave the throttles on Y leads or do they both need a seperate channel?
08-02-2017, 02:03 AM
#3
Thread Starter
Thank you for the information Andy.
Hopefully the team can come up with a solution on this outcome, as it is a little let down on a product I thrust, and hope to keep using for a long time to come.
Kind regards
Ivan
Hopefully the team can come up with a solution on this outcome, as it is a little let down on a product I thrust, and hope to keep using for a long time to come.
Kind regards
Ivan
