IGOS R/C

Need help to program JR 12X CROW function to my jet plane using 2 aileron/flap servos configuration.

Square Nozzle

My Feedback: (1)

Go to the BVM web site. On the left side of the home page is a listing of subjects. Scroll down to videos and open that item. You will find programing crow with the JR 12x.

IGOS R/C

Thanks John.
I use your infos to get the crow in my JR 12X. But now arise another issue. For SAFE I would like to get the option to switch ON or OFF the CROW during a flight. In other words. I would use a switch just to use flight system (flaps and elevator compensation) and still get another switch to use the crow mix. Is it possible? Can you help me again?
Thank you very much.
Isaac

Misha Javornik

Use a 3 position switch, normal flight -take off- landing. activte the crow position only for landing and you are set.

IGOS R/C

Thanks Misha
Using the suggested option I can't get the two stages normally used for aproaching and land.
Thank you.
Isaac

IGOS R/C

Thanks Misha.
Using this option I can't get the flaps two stages (approaching and landing) for crow and flaps/elevators conditions.
Thank you

IGOS R/C

Thanks Misha.
Using only one switch I can't get flaps on two stages (approaching and landing) for crow and flaps/elevators condition.
Thank you.
Isaac

IGOS R/C

Thanks Misha.
It seems that using only one switch I can't get flaps on two stages percentage (approaching and landing) for crow or for flaps/elevators condition.
Thank you.
Isaac

IGOS R/C

Thanks Misha.
It seems that if I use only one switch I can't get the two stages flaps (approaching and landing) for crow and flaps/elevators condition.
Thank you.
Isaac

IGOS R/C

Sorry by the copies.
My fault.
Isaac

Misha Javornik

will send you later this evening the whole setup for your 12x

Misha Javornik

Had to go out of town , did not forget , will send it to you in a couple of hours

Misha Javornik

Isaac , send me your e-mail and i will send you the images to program your radio

Misha

IGOS R/C

Hi Misha.
Here it goes: [email protected].
Isaac

IGOS R/C

Hi Misha
I have just print your programming. I'm gonna do step by step as informed.
Thank you very much for the help.
Isaac