8411's, 8511's and 8611's on li-on regulator
05-05-2004, 02:44 AM
#1
Senior Member
Thread Starter
Join Date: Nov 2003
Location: Oxford, UNITED KINGDOM
Posts: 231
Likes: 0
Received 0 Likes
on
0 Posts
8411's, 8511's and 8611's on li-on regulator
Hi,
Am just about to buy a fromeco li-on setup and just wondored if this was ok for these servos. I just was checking as in leaflet you get with the servos it says dont use with 6 volt systems. The regulator will be 5.5v so should be ok but confirmation of this will be appriciated.
regards
Matt
Am just about to buy a fromeco li-on setup and just wondored if this was ok for these servos. I just was checking as in leaflet you get with the servos it says dont use with 6 volt systems. The regulator will be 5.5v so should be ok but confirmation of this will be appriciated.
regards
Matt
05-05-2004, 10:39 AM
#2
RE: 8411's, 8511's and 8611's on li-on regulator
For US JR equipment, that set up should work just fine. I'm not sure on overseas equipment. You would need to contact MacGregor for further information.
