channel mix
#1
Member
Thread Starter
Join Date: Feb 2002
Location: Milford, CT
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
channel mix
Danny I have a PCM10 and I am using two servos for elevator can I use the elevator channel and another channel like the ailerons. I want to try to get away from a Y harness so I can adjust servo direction and end travel seperatly.
#2
channel mix
Do a mix elevator to the channel of your choice, the easiest is aux 3, but any of the others will work. Set the mix values to 100% and turn the trim on. If you have used aux 3, go to the trimmer function, and inhibit aux 3. If you used another channel, like aux 2, mix the channel to itself in another mix, and make the percentages -100% with the switch/knob in all positions. This should get it going. If you have any problems, feel free to give one of our techs a call at 877-504-0233