fun_fly_3D

My Feedback: (1)

Danny,

I recently switched from a futaba 9Cap to a JR 10x. the radion was very lightly used, but did not come with a manual. on my 9 cap, i could assign the dual rates to any switch i wanted to. I know on the JR that I can assign all of the rates to one switch (via a flight mode), but can i assign them individually to a switch that i prefer better than the pre-assigned ones or do I have to use the pre set ones?

Thanks,

Brian Ludwig
-Team Pacific Planes-

dsnyder

Assuming you are talking about the aircraft 10X, the flight mode switch must be one of the 3 'dual rate' switches.

John Redman

My Feedback: (8)

Just as Danny stated the rates will need to be on one of the rate switches. You cannot move the dual rates to another switch (say a mix or flap switch) which you could do on your Futaba.

fun_fly_3D

My Feedback: (1)

Ok. but can i move the elevator D/R switch to the aileron D/R switch?

Brian

dsnyder

If you are using flight modes, the flight mode switch can be any one of the 3 'dual rate' switches including the elevator or aileron. If not using flight modes, no, the function of the switches can't be changed.