Mastertech

My Feedback: (31)

Danny in reading the copying portion of the manual for the 10x it says only from a Datasafe or another 10x. I have a program in a 9303 I'd like to copy to a 10x. I know the manual for the 10X was written before the 9303 came out. Is it possible to transfer from the 9303 to the 10x?

Thanks for your support.

Tim

dsnyder

No, to transfer a model it must be like model to like model transmitter 10X air to 10X air, 9303 to 9303 etc. You can input the data manually as a starting point, but may require adjustment to fine tune the set up.

Mac_Man_UK

Unless you use a 3rd party piece of software.

Tommy_Gun

Is there such software?

If so, where can I acquire it?

Thanks

mervmatthews

Yes, I would like to know too please!!