dx7 question
#1
Junior Member
Thread Starter
My Feedback: (1)
Join Date: Mar 2003
Location: waterfordontario, CANADA
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
dx7 question
hi danny i have the dx7 and ar7000 receiver(wich is on the way to horizon for the firmware upgrade)
airplane is the falcon 120 with a jetjoe 1200 turbine and retracts
setup is the trouble 1 elevator servo
2 rudder servos
2 flap servos
2 aileron servos
1 throttle ecu channel
1 retract servo
1 steering servo
how would u set this up on the dx 7 tx i cant figure this out for the life of me
o and the failsafe how do i do that?
regards perry
airplane is the falcon 120 with a jetjoe 1200 turbine and retracts
setup is the trouble 1 elevator servo
2 rudder servos
2 flap servos
2 aileron servos
1 throttle ecu channel
1 retract servo
1 steering servo
how would u set this up on the dx 7 tx i cant figure this out for the life of me
o and the failsafe how do i do that?
regards perry
#2
My Feedback: (2)
Join Date: Feb 2002
Location: Cape Coral,
FL
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
RE: dx7 question
Perry,
I would set it up like this:
Ch1- throttle
Ch2- Ailerons with a Y harness or matchbox
Ch3- Elevator
Ch4- Rudders with a matchbox
Ch5- gear
Ch6 (aux1)- flaps with a matchbox
Ch7 (aux2)- steering with a pmix to the rudder
Anthony Greco, Jr.
Team JR
I would set it up like this:
Ch1- throttle
Ch2- Ailerons with a Y harness or matchbox
Ch3- Elevator
Ch4- Rudders with a matchbox
Ch5- gear
Ch6 (aux1)- flaps with a matchbox
Ch7 (aux2)- steering with a pmix to the rudder
Anthony Greco, Jr.
Team JR