Tight Receiver Intallation
#1
Thread Starter
My Feedback: (7)
Join Date: Feb 2002
Location: Durham,
NC
Posts: 779
Likes: 0
Received 0 Likes
on
0 Posts
Tight Receiver Intallation
I am building a small plane with a narrow fuselage. The smallest receiver I have is the AR 6200. I can't come up with any way to mount the receiver without having at least one of the four (remote receiver included) antenna wires bent. Is there any problem with that? Most likely, Both wires on the main receiver will be bent upward and the remote receiver wires will be straight. The bends will be gentle against the inside wall of the fuselage rather than sharp 90 degree bends. Has anyone else done the same thing? Have you encountered any problems with an installation like that?
Thanks,
Brian
Thanks,
Brian