10x Two Aileron Servo Setup
 

I have installed one aileron servo in each wing. The left servo is pluged into Aux1 channel and the right is pluged into the aileron channel. I have selected flaperons as the wing type. I do not plan to use flaps. The aileron responds correctly to stick movements but I cannot adjust them using the travel adjustment (ATV) function. What am I missing? Someone told me I needed to inhibit the flap switch. I tried that but it did not work.

Thanks Ron

RE: 10x Two Aileron Servo Setup
 

To not have the servos move with the left slider, go to code 17 and inhibit the flap channel. There should be no reason why travel adjust will not work for each channel. Keep in mind that each channel is independent of one another when making changes to the travel adjust. If it still persists, try going into a clear model, do a reset of the model, and try it again.